De-Binding With Metalbind - Opus Atlas 190 User Manual

DE-BINDING WITH METALBIND

6
1. Lift the binding handle(1) up to the open position.
2. If fitted remove adjustable stop.
3. Ensure the clamp lever(2) is completely to the left,open.
4. Put the bound document flat on the equipment face down, back cover up.
5. Push the bound document, channel against the back support,firmly.
6. Open the bound document 5 to 6 pages from the back cover.
De-binding
C-BIND SYSTEM
7
Accessories for binding, measuring, de-binding covers of the C-Bind system.
• Channel width selecting tool (6)
• O.CB Insert for Atlas 190. for binding C-Bind covers, two part kit for all covers (dig.1)
• O.CB Debinding tool for Atlas 190 - de-binding wedge (dig.2) and AA cover de-binding jig tool (dig.3)
dig. 1
7. Fit the right end of the wedge (5) blade edge towards
8. Move the clamp lever (2) to the right till you feel
some resistance, holding the lever.
1
9. Push down the binding handle (1) carefully, hol-
10. Lift the handle (1) up, release clamp lever (2) and re-
2
11. Make the planned changes to the document and
dig. 2
the channel, in the right hook (4) then place the left
end of the wedge into the left hook (4).
ding the clamp lever (2) at the same time, move the
handle (1) up and down at the same time move the
clamp lever (2) to the right carefully until the pages
are just loose enough to come out of the channel.
move the document together with the wedge, then
take the wedge out of the document carefully.
re-bind. The cover may be re-used (a maximum of
three times).
dig. 3