Numbering Your Photos Sequentially; Calibrating The Needles On The Status Gauge - Epson R-D1 User Manual

7. Focus on the subject again and press the shutter button down.
Note:
For more information, see the documentation for your flash.

Numbering Your Photos Sequentially

You can number your photos in sequence across different memory
cards.
1. Use the JOG dial to select Sequential Numbering in the Basic
Setup menu, and press the ENTER button. For details on using the
menu, see "Basic Setup menu" on page 42.
The Sequential Numbering screen is displayed.
On (default) Numbering continues even when the
memory card is replaced.
Off Number is reset to 1 when the memory
card is replaced.
2. Use the JOG dial to highlight On or Off, and press the ENTER
button. The new setting is saved and the screen returns to the Basic
Setup menu.
31
Taking Pictures
Downloaded from ManualsCamera.com Manuals
Calibrating the Needles on the Status
Gauge
You can check the number of remaining photos, photo quality,
remaining battery power, and white balance using the status gauge on
the top of the camera. There are 4 needles on the gauge. If any of these
needles becomes inaccurate, follow the steps below to adjust it.
1. Use the JOG dial to select Calibrate Needles in the Camera
Settings menu, and press the ENTER button. The Needle Calibration
screen is displayed. For details on using the menu, see "Camera
Settings menu" on page 41.