Asus X99-E-10G WS User Manual page 130

Network Stack Driver Support [Disabled]
[Disabled]
[Enabled]
Redirection Support [Disabled]
This item allows you to enable or disable redirection support.
Configuration options: [Enabled] [Disabled]
Next Boot after AC Power Loss [Normal Boot]
[Normal Boot]
[Fast Boot]
Boot Logo Display [Auto]
[Auto]
[Full Screen]
[Disabled]
The following items appears only when you set the Boot Logo Display item to [Disabled].
Post Report [5 sec]
This item This item allows you to select a desired waiting time of the POST report from
0 to 10 seconds or until <ESC> is pressed.
The following items appears only when you set the Boot Logo Display item to [Full Screen]
or [Auto].
Post Delay Time [3 sec]
This item This item allows you to select a desired additional POST waiting time to
easily enter the BIOS Setup. You can only execute the POST delay time during normal
boot. The values range from 0 to 10 seconds.
DirectKey (DRCT) [Enabled]
[Disabled]
[Enabled]
Boot up NumLock State [Enabled]
[Enabled]
[Disabled]
Wait For 'F1' If Error [Enabled]
Enable this item for the system to pause until the F1 key is pressed when any error occurs.
Configuration options: [Disabled] [Enabled]
Option ROM Messages [Force BIOS]
This item allows you to set the display mode for Option ROM.
Configuration options: [Force BIOS] [Keep Current]
3-60
Select to skip the network stack driver from loading during POST.
Select to load the network stack driver during POST.
Returns to normal boot on the next boot after an AC power loss.
Accelerates the boot speed on the next boot after an AC power loss.
Auto adjustments for Windows requirements.
Maximize the boot logo size.
Hide the logo during POST.
The system will only turn on or off when the reset button is pressed.
Allow the system to turn on and go to the BIOS Setup directly when the
reset button is pressed. Connect the 2-pin connector of the chassis reset
button cable to the onboard DRCT header to support this function.
Set the power-on state of the NumLock to [On].
Set the power-on state of the NumLock to [Off].
Chapter 3: BIOS Setup