ION F-18 User Manual page 19

(2) UPS Output Connection
The output of the UPS is IEC socket-types. Simply plug the load power cord
to the output sockets to complete connection. Use one cord for every 5A
load.
1K(S)/1.5K(S)/ 2K(S)
The wiring configuration is shown as the
following procedure:
a) Remove the small cover of the terminal block
2
b) Use 2.5mm wires for wiring configuration
c) Upon completion of the wiring configuration,
please check whether the wires are securely
affixed
d) Put the small cover back to the rear panel
Caution:
Do not connect equipment which would overload the UPS system (e.g. laser
printers)
(3) EPO Connection:
User can select the polarity of EPO, EPO is Normally close as default setting.
NO
Normally the EPO connector is open on the rear panel. Once the connector is
closed with a wire, the UPS would stop the output until the EPO status is disabled.
Disable the EPO status
Model No.
3K(S)
Output Socket (pcs)
8 * IEC320 C13
8 * IEC320 C13 + 1 * C19
Connection diagram
Enable the EPO status
19