Additional Documentation; Repacking For Shipment; Optional Accessories - Keithley 263 Instruction Manual

GENERAL INFORMATION
1.7 UNPACKING .AND INSPECTION
The Model 263 was carefully inspected and packed before
shipment. Upon receiving the instrument, carefully un-
pack all items from the shipping carton and inspect for
any obvious signs of damage that might have occurred
during shipment. Report any damage to the shipping
agent immediately. Retain the original packing material
in case reshipment becomes necessary.
1.7.1 Shipment Contents
The following items are included with every Model 263
shipment:
Model 263 Calibrator/Source
Model 7024-3 Triax to Traix Cable (3 ft.)
Instruction Manual
Quick Reference Guide
1.7.2 Additional Documentation
If an additional instruction manual is required, order the
manual package, Keithley Part Number 263-901-00. The
manual package includes an instruction manual and all
pertinent addenda.
If an additional Quick Reference Guide is required, order
Keithley Part Number 263-903-00.
1.8 REPACKING FOR SHIPMENT
Before shipment, the unit should be carefully packed in
its original packing carton using all original packing
materials.
if the instrument is to be returned to Keithley Instruments
for repair, complete the following:
1. On the shipping label, indicate the warranty status of
the instrument and write;
ATTENTION REPAIR DEPARTMENT
2. Complete and include the service form at the back of
this manual.
1.9 OPTIONAL ACCESSORIES
The following accessories for the Model 263 are available
from Keithley Instruments, Inc. Contact your Keithley
representative or the factory for information on obtaining
these accessories.
Models 1019A-1 and 1019A-2 are fixed shelf-type rack
mounting kits for half-rack, 127mm (Wz in.) high instru-
ments (such as the Model 263). The 1019A-1 kit mounts
one instrument and the 1019A-2 mounts two.
Models 101951 and 1019S-2 are sliding shelf-type mount-
ing kits for half-rack, 127mm (5% in.) high instruments
(such as the Model 263). The 10195-l kit mounts one in-
strument and the 10195-2 mounts two.
Model 4804 is a 2-slot male BNC to 2-lug female triaxial
adapter. Used to adapt the supplied triaxial output cable
of the Model 263 to 2-lug BNC input connectors.
Models 6011 and 6011-10 Trixial Cables are made up of
three feet of triaxial cable that is terminated with a triax
plug on one end and three alligator clips on the ofher end.
The Model 6011-10 is a similar cable 10 feet in length.
Model 6012 Triax to UHF Adapter allows the Model 263
to be used with accessories having UHF type connectors.
Model 6105 Resistivity Chamber is a guarded test fixture
for measuring voltage and surface resistivities. The unit
assures good electrostatic shielding and high insulation
resistance. The complete system requires the use of an ex-
ternal voltage supply such as the Model 263 as well as a
picoammeter. Volume resistivity up to lOWan and sur-
face resistivity up to 10x8n can be measured in accordance
with ASTM test procedures. Sheet samples 64 to 102mm
(12~12 x 4") in diameter and up to 6.4mm (IL") thickness
can be accommodated. Excitation voltages up to 1OOOV
may be used.
Model 6146 Triax Tee Adapter allows the simultaneous
connection of two triaxial cables to the single triaxial out-
put of the Model 263.
Model 6147 Triax to BNC Adapter allows the Model 263
output to be connected to accessories having BNC con-
nectors.
l-2