Safety First; Tools And Supplies Required For Installation - Harmar Mobility AL625 Installation & Owner's Manual

SAFETY FIRST

1.
The power chair must have the brake engaged and be securely attached to the lift during transport. The
straps, when properly adjusted and maintained, are intended to constrain the power chair or scooter. The straps
should be checked to make certain they are in good condition before each use.
WARNING: FAILURE TO ENGAGE THE BRAKE AND SECURELY STRAP THE
POWER CHAIR/SCOOTER TO THE LIFT DURING TRANSPORT
COULD RESULT IN SERIOUS PERSONAL INJURY OR DAMAGE
TO THE LIFT, THE POWER CHAIR, AND VEHICLES.
2.
After the Power Chair/Scooter has been lifted into the vehicle, turn the control cut-off switch off. This will
prevent inadvertent operation of the lift by remote control and/or hand held pendant. Remember for the
control cut-off switch – "RED IS ON."
ALWAYS PUSH THE POWER CUT-OFF SWITCH TO THE OFF POSITION WHEN
NOT OPERATING THE LIFT.
3.
The Tracker lift has a maximum weight lifting limit of 350 pounds
WARNING: DO NOT EXCEED THE MAXIMUM CAPACITY OF LIFT OR DAM-
AGE TO THE LIFT AND/OR SERIOUS INJURIES MAY OCCUR.
4.
The Tracker lift has been designed to lift power chairs and scooters. It has not been designed or intended to
lift any other object. Lifting people or objects other than power chairs may be dangerous.
5.
Keep the area underneath of the lift clear at all times.

TOOLS AND SUPPLIES REQUIRED FOR INSTALLATION

___
DRILL
___SMALL FLASHLIGHT
___ASSORTED WRENCHES AND SOCKETS (7/16", 9/16" and 3/4" are important)
___ 5/32", 3/16, 1/4", and 5/16" ALLEN WRENCHES
___STANDARD SCREWDRIVER
___PHILLIPS HEAD SCREWDRIVERS, #1 & #2
___SILICON CAULK (RTV)
___ TAPE MEASURE
AL625
REV: 1-24-12
.
___ASSORTED DRILL BITS
___ELECTRICAL TAPE
___PORTABLE VACUUM
Page 4