Harmar Mobility AL625 Installation & Owner's Manual page 17

STEP 10
ADJUSTING THE VERTICAL – HORIZONTAL TRANSITION
The relay circuit in the Tracker is designed to end lifting and begin horizontal travel into the vehicle when the limit
switch in the back boom weldment is contacted. The Tracker is shipped with a factory setting for this limit switch.
Depending on the weight of the power chair/scooter you may need to adjust the point where the lift ends, especially
if the load being carried is near the weight limit of 350 pounds.
To adjust, loosen the jam nut on the screw, and turn the contact screw inward to increase the upward lift, OR
outward to reduce the upward lift.
AL625 Page 17
REV: 1-24-12