Unpacking The Shipping Box - IBM EXP5060 Quick Start Manual

Unpacking the shipping box

Important: Do not remove the storage expansion enclosure from the shipping box until the support rails
are installed in the rack cabinet. You must install the support rails in the rack cabinet before
you install the storage expansion enclosure.
The disk drive modules (DDMs) that come with the storage expansion enclosure are packaged in a
smaller box inside the shipping box. To unpack the shipping box, complete the following steps:
1. Remove the following items from the shipping box. Do not remove the EXP5060 from the shipping
box at this time.
v Box containing the mounting hardware kit
v Six full or empty boxes of DDMs
Note: The DDMs are packaged ten per box. The minimum order is 20 DDMs, so at least two of the
boxes are full. If you ordered less than the maximum number of 60 DDMs, one or more of
the boxes are empty.
v Box containing storage expansion enclosure handles
v Box containing the power cords, Fibre Channel signal cables, and documentation
2. Check the items in the preceding list to make sure that you received all the necessary parts. See the
"Inventory list" on page 5 for the parts that are included with the storage expansion enclosure.
4