Arctic King WPPH-06CR5 Instruction Manual page 11

Operation Instructions
COOL operation
-Press the "MODE" button until the "COOL" indicator light comes on.
-Press the ADJUST buttons "+" or "-" to select your desired room temperature. The temperature
can be set within a range of 17°C~30°C/62°F~86°F.
-Press the "FAN SPEED" button to choose the fanspeed.
DRY operation
-Press the "MODE" button until the "DRY" indicator light comes on.
-Under this mode, you cannot select a fan speed or adjust the temperature. The fan motor
operates at LOW speed.
-Keep windows and doors closed for the best dehumidifying effect.
-Do not put the duct to window.
FAN operation
-Press the "MODE" button until the"FAN " indicator light comes on.
-Press the "FAN SPEED" button to choose the fan speed. The temperature can not be adjusted.
-Do not put the duct to window.
Other features
SLEEP/ECO operation
This feature can be activated from the remote control ONLY. To activate SLEEP feature, the set
temperature will increase by 1°C/2°F) in 30 minutes. The set temperature will then increase by
another 1°C/2°F) after an additional 30 minutes. This new temperature will be maintained for 7
hours before it returns to the originally selected temperature. This ends the Sleep mode and the
unit will continue to operate as originally programmed.
NOTE: This feature is unavailabe under FAN or DRY mode.
FOLLOW ME/TEMP SENSING feature(optional)
NOTE:This feature can be activated from the remote control ONLY. The remote control
servesas a remote thermostat allowing for the precise temperature control at its location.
To activate the Follow Me/Temp Sensing feature, point the remote control towards the unit
and press the Follow Me/Temp Sensing button. The remote display is actual temperature
at its location. The remote control will send this signal to the air conditioner every 3
minutes interval until press the Follow Me/Temp Sensing button again. If the unit does
not receive the Follow Me/Temp Sensing signal during any 7 minutes interval, the unit
will beep to indicate the Follow Me/Temp Sensing mode has ended.
Operation