Installation Instructions; Installation Requirements - Whirlpool W10856086A Use & Care Manual

INSTALLATION INSTRUCTIONS

Installation Requirements

Tools and Parts
Gather required tools and parts before starting installation.
Tools needed:
Adjustable or open end
wrenches 3/8" (10 mm)
and 1/2" (13 mm)
4" min
(102 mm)
Wood block
Pliers that open to 1 ⁄ "
9
16
(39.5 mm)
Parts supplied:
NOTE: All parts supplied for installation are in the washer
basket. Inlet hoses and washers are not included.
Cable tie
Transport bolt hole
plugs (4)
Level
Ruler or measuring tape
3/8" (10 mm) socket
wrench
U-shaped hose form
Optional tools:
Flashlight
Alternate parts:
(Not supplied with washer)
Your installation may require additional parts. To order, please
refer to toll-free numbers on the back page of this manual.
If you have:
Laundry tub or standpipe
taller than 55" (1.4 m)
Overhead sewer
Floor drain system
Drain hose too short
Water faucet beyond
reach of fill hose
Stack Kit:
Are you planning to stack your washer and dryer? To do so you
will need to purchase a Stack Kit.
To order, call the dealer from whom you purchased your washer
or refer to the "Assistance or Service" section. Ask for Part
Number W10882520.
Bucket
You will need
Sump pump system
(if not already available)
Standard 20 gal. (76 L) 30"
(762 mm) tall drain tub or utility
sink, sump pump and connectors
(available from local plumbing
suppliers)
Siphon Break Kit
Part Number 285834
Connector Kit (x2)
Part Number 285835
Additional Drain Hose
Part Number 8318155
Extension Drain Hose
Part Number 285863
Connector Kit Part Number 285835
2 longer water fill hoses:
6 ft (1.8 m) Part Number 76314
10 ft (3.0 m) Part Number 350008
17