Whirlpool W10856086A Use & Care Manual page 26

TROUBLESHOOTING
First try the solutions suggested here or visit our website at www.whirlpool.com/product_help –
If you experience
Error Code Appears in Display (cont.)
(service)
F20 or F60
(service)
F24
(service)
All other F.. failures
26
In Canada www.whirlpool.ca for assistance and to possibly avoid a service call.
Possible Causes
Failure of an electronic component.
Too much laundry for a program/cycle
with a small maximum load.
Too much inlet water.
Failure of an electrical component.
Solution
Turn off and unplug the washer. Close the water faucet.
See the "Assistance or Service" section to contact a service
representative.
Select and start the Rinse & Spin program to complete the
interrupted wash program/cycle. Do not overload the washer.
Follow the maximum load size indicated in the "Program/
Cycle Guide."
Turn off the water faucet. Touch and hold the Power button for
at least 3 seconds to drain the water; wait until the drain phase
has ended (End will appear on the display).
Turn on the water faucet again. If water immediately flows into
the washer without a program/cycle being started, an electrical
component has failed. Close the water faucet, turn off and
unplug the washer. See the "Assistance or Service" section to
contact a service representative.
Touch and hold the Power button for at least 3 seconds to
reset the control. If the problem persists, turn off and unplug
the washer. Close the water faucet. See the "Assistance or
Service" section to contact a service representative.