Electrical Requirements; Installation Instructions - Whirlpool W10856086A Use & Care Manual

Electrical Requirements

A 120-volt, 60 Hz., AC-only, 15- or 20-amp, fused electrical
n
supply is required. A time-delay fuse or circuit breaker is
recommended. It is recommended that a separate circuit
breaker serving only this appliance be provided.
This washer is equipped with a power supply cord having
n
a 3-prong grounding plug.
To minimize possible shock hazard, the cord must be plugged
n
into a mating, 3-prong, grounding-type outlet, grounded in
accordance with local codes and ordinances. If a mating outlet
is not available, it is the personal responsibility and obligation
of the customer to have the properly grounded outlet installed
by a qualified electrician.
If codes permit and a separate ground wire is used, it is
n
recommended that a qualified electrician determine that
the ground path is adequate.
Do not ground to a gas pipe.
n
Check with a qualified electrician if you are not sure the
n
washer is properly grounded.
Do not have a fuse in the neutral or ground circuit.
n
20

Installation Instructions

NOTE:
To avoid floor damage, set washer onto cardboard
before moving it.
1.
Move washer
48"
(1.2 m)
It is necessary to remove all shipping materials for proper
operation and to avoid excessive noise from washer.
Move washer to within 48" (1.2 m) of its final location. It must
be in a fully upright position.
2.
Remove transport bolts from
washer
Loosen bolts with a 3/8" (10 mm) wrench. Once the bolt
is loose, wiggle and completely pull out the bolt and
shipping plug.