Brother GT-3 SERIES Basic Operation Manual page 69

All Whites Tube Cleaning
Sequence of All Whites Tube Cleaning (firmware ver. 2.10 or higher)
All Whites
:
Set Maintenance
Retrieving
Cartridge
White Ink
Repeats the steps four times for GT-381(W1-W4), two times for GT-361 (W1, W2)
<Note>
 If you execute Tube Cleaning one by one, then the first "Retrieving White Ink" is skipped.
 Insert Capping Cartridges (option) in place of White Ink Cartridge when you leave the GT-3 printer
unused for more than two weeks.
(1) Fill the bottle with Maintenance Solution. Confirm that at least more than 250 ml per one Print Head is in the
bottle.
(2) Confirm in advance the amount of the Waste Ink in the Waste Ink Tank (The amount of waste liquid left in the
Waste Ink Tank is less than half of the full amount).
(3) Confirm that the printer is either [ Standby ] or [ Ready ].
(4) Select [ Maintenance ] > [ White Tube Cleaning ] from the menu and press OK Button.
(5) Select [ All Whites ] then White Ink retrieval starts and the countdown is indicated on the Display. Please wait
until the retrieval finishes (4 minutes).
(6) When White Ink retrieval is finished, the message [ Set Maintenance Cartridge ] is indicated on the Display.
Remove the White Ink Cartridge of W1 and insert the Maintenance Cartridge to W1 slot and press OK Button.
Confirm that the tube of the Maintenance Cartridge reaches to the bottom of the bottle.
<Note>Insert the tube to the bottom of the bottle.
(7) [ Close Air-in Cap ] is indicated. Confirm that the Air-in Cap is capped (closed) and press OK Button. The
pump starts turning to load the Maintenance Solution.
Tube
Set Filter
Cleaning
Cartridge
GT-3 Series
Load Mainte-
Insert White Ink Cartridge or
nance Solution
Capping Cartridge
5. Maintenance
0192Y
0193Y
60