Service; Checking The Ink Film Reserve; Changing The Ink Film - Philips MAGIC 5 ECO PPF 632 User Manual

Philips fax machine user manual
Hide thumbs Also See for MAGIC 5 ECO PPF 632:
Table of Contents

Advertisement

12 Service

Disruptions
Should disruptions occur, follow the instructions on
the display and on the error report.
EN

Checking the Ink Film Reserve

1 Press OK, 46 and OK.
2 The number of pages that can still be printed with the
ink film is shown on the display.
3 Press STOP to return to the starting mode.
If the ink film used up or if there is no ink film in the ma-
chine, a message appears on the display.

Changing the ink film

Original Consumable Materials
Use only original consumable materials. These are
available from a specialised retailer or through our
order service (see back side of this user manual). Oth-
er consumable materials can cause damage to the de-
vice.
Instructions on the Packaging
Follow the instructions on the packaging of the con-
sumable materials.
Introduction to Plug'n'Print Card
For receiving or copying documents, an ink film must be
inserted in your device. Your device is delivered with an al-
ready inserted free ink film for a few test pages. For this
film, you do not require any Plug'n'Print card (= chip card
with information regarding ink film capacity). For every
next ink film that you insert, you must load the capacity
memory with the included Plug'n'Print card.
1 Remove the paper from the paper feeder and take the
paper tray out of the device.
2 Open the device by lifting the panel using grip in the
centre and folding it up.
Lock the cover of the device completely into place
when opening the device. You could be injured if
the cover falls while you are working on the de-
vice.
28
3 Grip the rear ink film roll at both the sides and place it
next to the front ink film roll.
4 Remove both the rolls from the device. The used ink
film cannot be reused.
The messages and copies you have printed out
can be read from used ink films. Consider data
protection issues when disposing of used ink
films.
5 Pull the used Plug'n'Print card out of the plug socket
on the left hand side next to the ink film tray. The
Plug'n'Print card cannot be reused.
6 Carefully remove the rubber bands from the new ink
film. Make sure that the film is not damaged!
Philips PPF 631 · 632 · 675

Advertisement

Table of Contents
loading

Table of Contents