Table of Contents
Advertisement
S
TARTING THE NETWORK CARD SETUP UTILITY
Once installed, you can launch the Network Card Setup utility by selecting Start >
Programs > Okidata > Network Card Setup.
M
ANUALLY CONFIGURING THE
If there is no DHCP protocol to automatically assign IP addresses to devices on your
network, you might want to set the IP Address, Subnet Mask and Default Gateway Address
for your printer manually.
1.
In the "Network Card Setup" pane, click to select the printer.
2.
Click the Printer Setting icon. The Printer Settings dialog displays.
3.
Select Manual. In the Details section, you can now edit the IP Address, Subnet
Mask and Default Gateway Address.
4.
Click Apply. The "Setting Password" dialog displays.
5.
Enter the password. The default password is the last 6 digits of the MAC Address
(upper case).
6.
Click OK. Allow a few seconds for the changes to save and the printer to
automatically restart before the "Setup Complete" message box appears.
NOTE
If your printer stops at any time, you can restart it by selecting Printer >
Restart Printer in the "Network Card Setup pane".
C
HANGING THE ADMIN PASSWORD
To change the Admin Password for your printer:
1.
Select Settings > Change Password.
2.
Enter and verify the new password as requested.
3.
Click OK. Allow a few seconds as the settings are saved and the printer
automatically restarts.
E
/
NABLE
DISABLE THE PRINTER WEB PAGE
To enable/disable access to the Printer Web Page from the Network Card Setup utility:
1.
Select Settings > Printer Settings.
2.
Select the "Web Page Setting" tab and select Enable Web Page Setting or Disable
Web Page Setting.
3.
Click Apply. The "Setting Password" dialog box displays.
4.
Enter the admin password as requested and click OK.
5.
The "Setup Complete" message is displayed.
If you now try to view the Printer Web Page, an error message is displayed (containing
instructions on how to enable the Printer Web Page again).
IP
ADDRESS
Windows > 15
Advertisement
Table of Contents
