Table of Contents
Advertisement
3.2 Installation
1. Hardware detection
# lspci –vvvv
Check the outcome and confirm your system has recognized
B200P/BE200P. If it has been recognized, "ISDN controller" will be
displayed in the output information like that:
02:09.0 ISDN controller: Cologne Chip Designs GmbH ISDN network
Controller [HFC-4S] (rev 01)
Subsystem: Cologne Chip Designs GmbH Device e884
Control: I/O+ Mem+ BusMaster- SpecCycle- MemWINV- VGASnoop-
ParErr- Stepping- SERR+ FastB2B- DisINTx-
Status: Cap+ 66MHz- UDF- FastB2B- ParErr- DEVSEL=medium >TAbort-
<TAbort- <MAbort- >SERR- <PERR- INTx-
Interrupt: pin A routed to IRQ 217
Region 0: I/O ports at dff0 [size=8]
Region 1: Memory at feafb000 (32-bit, non-prefetchable) [size=4K]
Capabilities: [40] Power Management version 2
Flags: PMEClk- DSI+ D1+ D2+ AuxCurrent=0mA
PME(D0+,D1+,D2+,D3hot+,D3cold-)
Status: D0 NoSoftRst- PME-Enable- DSel=0 DScale=0 PME+
Kernel driver in use: wcb4xxp
Kernel modules: wcb4xxp
If B200P/BE200P is not recognized by the system, you have to power off
and take out the card to insert it into another PCI slot.
2. Software installation
Some dependencies are crucial. If any of them is absent, the software
OpenVox Communication Co. LTD.
B200P/BE200P on DAHDI User Manual
Figure 4 Hardware detection
17
URL: www.openvox.cn
Advertisement
Table of Contents
