Table of Contents
Advertisement
1-1. Installation
6. Attach the front and rear brackets to the outside of the
rack temporarily using the eight screws (B5x8)
supplied with RMM-30.
Rack
12.7
31.75
12.7
31.75
B 5x8
Front bracket
7. While pressing the stoppers of the inner rails, slide the
inner rails fully into the outer rails.
Rack
Inner rail
c
. Be sure to mount the DFR-E3000 in the rack with two or
more persons.
Trying to handle this job by one-person could occur to
injury.
. Be careful not to get caught your hand and finger in the
rack mount rail when installing the unit in the rack.
1-4
Rack
Outer rails
B 5x8
31.75
Rear bracket
Unit : mm
Outer rail
Stopper
8. After confirming that the DFR-E3000 can be moved
smoothly, tighten the screws (B5x8) secured
temporarily in the step 6.
n
When securing the front brackets to the rack by
screws, pull out the DFR-E3000 about 20 cm
(8 inches), and fasten the screws of the front brackets
to the rack.
9. After installing the DFR-E3000 in the rack, secure the
unit to the rack by the prepared four screws (RK5x16)
and four washers.
Rack
Washers
RK 5x16
Washers
RK 5x16
n
When the DFR-E3000 is mounted in a rack, the maximum
traveling distance is illustrated below.
581 (Maximum traveling distance)
Distance to the center of the slide rail
Height of the unit mounted in a rack
Unit : mm
DFR-E3000
Advertisement
Table of Contents
