Gravely ZT Xl Bagger Owners Operating Manual And Parts List page 15

33
36
31
33
36
Figure 13
4. Install the cover assembly on the rear bagger
mount by placing the shaft on the cover assembly in
the slots on the mounting bracket. Rotate the
assembly up against the bracket and secure with
3/8" wing knobs (item 3), 3/8" x lock washers
(item 32) and 25/64" x 1-1/2 x 1/8" washers
(item 34).
5. Install the reinforcing straps (item 27) on the right
and left side of the bagger. Secure each strap to the
stud on the bagger assembly with a hair pin #25
(item 21) and to the bracket on the unit frame with a
clevis pin 3/8" x 3/4" (item 28) and an external hair
pin (item 22).
37
29
29
30
32
3
34
INSTALL BAG ON FRAME (FIGURE 15)
1. Thread the bag frames (item 26) through the sleeve
on the open end of the mesh bags (item 24).
2. Install the 3/8 x 1/2 x 3 plastic tubes (item 25) on
the ends of the bag frames (item 26) and push the
ends together.
NOTE: The rope handle on the bottom of the bag will
point to the outside when the bag is assembled correctly.
GB – 15
10
21
22
28
27
Figure 14