Gravely ZT Xl Bagger Owners Operating Manual And Parts List page 11

INSTALL SHEAVE AND SHEAVE ADAPTER
(FIGURE 6 AND 7)
WARNING: Keep discharge chute, wing knobs
and belt covers for re-installation when the
bagger kit is removed.
1. Remove the wing knobs and discharge chute from
unit. Save wing knobs to install the blower bracket.
2. Remove mounting hardware and right belt cover
from mower deck (figure 6).
NOTE: Only remove the nut holding down the belt cover
and the loose washer. Keep the bolts in place on the
deck.
Wing Knobs
IMPORTANT: Keep the hex bolt for re-installation when
the bagger kit is removed.
NOTE: The washer is used for installing the sheave
(item 13) and sheave adapter (item 14) in step 4.
3. Remove hex bolt and washer from right mower
deck spindle (figure 7).
4. Install sheave adapter (item 14), sheave (item 13),
and washer on right mower deck spindle with 3/8" x
1-3/4" hex bolt (item 11). See (figure 7).
NOTE: Two sheave adapters are suppliled with unit. Use
the sheave adapter (item 13) that matches the holes in
the pulley (item 13). Other sheave adapter is not
required.
Discharge Chute
Right Belt
Nut
Cover
Washer
Do not remove these
nuts and bolts.
Figure 6
Save this hex bolt to run
the mower without the
bagger installed.
Washer
Washer
GB – 11
Right Mower
Deck Spindle
11
13
14
Figure 7