Replacing Feed Stepping Motor - ELNA eXperience 620 Service Manual

REPLACING FEED STEPPING MOTOR

TO REMOVE:
1. Remove the belt cover and base (see pages 6, 7).
2. Remove the snap ring (E-3).
3. Remove the setscrews (A), (B). Remove the feed stepping motor.
TO ATTACH:
4. Follow the above procedure in reverse.
NOTE: Adjust the stretch stitch feed balance after the replacement. (See page 19)
Feed stepping motor
Setscrews (B)
Snap ring E-3
Setscrews (B)
Setscrews (A)
33
MODEL: eXperience 620
Snap ring E-3