Adjusting The Bobbin Winding Switch - ELNA eXperience 620 Service Manual

ADJUSTING THE BOBBIN WINDING SWITCH

1. Enter adjusting mode.
2. Remove the top cover (see page 5).
3. Loosen the setscrews to adjust the position of the switch fixing plate.
The led should show "][" when the bobbin winder spindle is set to the bobbin winding position, and/
or "||" when the bobbin winer spindle is returned to the sewing position.
4. Tigthen the setscrew.
5. Attach the top cover.
TO ENTER ADJUSTING MODE
1. Turn the power on while pressing
the "–" of zigzag width button and
"+" of stitch length button.
Bobbin winding shaft
Setscrews
Switch fixing plate
2. Press the "+" of stitch length
button to select "9".
(BOBBIN WINDING OFF)
35
MODEL: eXperience 620
(BOBBIN WINDING ON)
ON
OFF