Replacing Printed Circuit Board "K" And "F - ELNA eXperience 620 Service Manual

MODEL: eXperience 620

REPLACING PRINTED CIRCUIT BOARD "K" AND "F"

REPLACING PRINTED CIRCUIT BOARD "K"
TO REMOVE:
1. Remove the front cover unit (see page 8)
2. Remove the set screws "A" and the printed board "K".
TO INSTALL:
3. To install the slide volume, follow the procedure above in reverse.
• Check to ensure that the slide volume moves smoothly back and forth.
REPLACING PRINTED CIRCUIT BOARD "F"
TO REMOVE:
1. Remove the front cover unit. Remove the printed board "K".
2. Remove the setscrews (B). Remove the printed circuit board "F".
TO INSTALL:
3. To install the printed circuit board "F", follow the procedure above in reverse.
Setscrew (A)
Setscrew (A)
Setscrew (A)
Setscrew (A)
Printed circuit board "K"
Setscrew (A)
Slide volume
Printed circuit board "F"
Setscrew (B) x2
27