Service Access (5) - ELNA eXperience 620 Service Manual

REPLACING THE FRONT COVER (UNIT)
TO REMOVE:
1. Remove the face cover (unit), top cover (unit) and belt cover. (See page 4, 5, 6)
2. Loosen the setscrews (A), (B) and (C).
3. Then remove the front cover (unit).
4. Disconnect the connector for printed circuit board-F and flexible flat cable from the printed board-A.
NOTE: Never pull on cord when disconnect the cables from the circuit board.
TO ATTACH:
5. Follow the procedure in reverse.
Setscrew (C)

SERVICE ACCESS (5)

Setscrew (A)
Setscrew (B)
Setscrew (B)
Connector for bobbin
winding switch
Front cover
Flexible flat cable
8
MODEL: eXperience 620
Setscrew (A)
Setscrew (C)