Crease/Fold Mechanism - Horizon Fitness CRF-362 User Manual

1-1-2

Crease/Fold Mechanism

This section describes the sheet flow from the feed section through the creasing and folding section to the
delivery section.
3
The crease is
made in the de-
Second First
sired position. (Up
to 10 lines)
The creasing depth
can be adjusted.
(See page 72
for details.)
13130
10102B1
Creasing Section
4
When the sheet is folded
twice, the sheet is folded
on a crease in the 1st fold
unit.
When the sheet is folded
once, the sheet passes
through the 1st fold unit,
and is transported to the
13130
10102C1
2nd fold unit.
First Fold Unit
CRF-362
2
The sheet is aligned with the register guide while it is trans-
ported to the creasing units. If the sheet tilts against the regis-
ter guide, the crease will be skewed.
[ Tips for Making Crease Parallel to the Sheet ]
Adjust the following:
• Align the sheet with the register guide completely.
→ If necessary, increase the pressure of the transport rollers.
See the Quick Start Guide for details.
• Transport the sheet parallel to the creasing units.
→ If necessary, adjust the tilt of the register guide. See the
Quick Start Guide for details.
1
Sheets are separated by the fluff and
separation air, and then fed one by
one.
Adjust the following:
• Separation/fluff air
• Table height
• The height of the double feed stop
5
Second Fold Unit
Features of the Machine
(See page 68 for details.)
(See page 66 for details.)
pad (See page 67 for details.)
The sheet is folded on
a crease in the 2nd fold
unit. If the sheet has
wrinkles, adjust the roller
gap. (See page 75 for
details.)
13130
10102D1
13130
10102A1
13