Command Control via the Network
When the projector connects network, the projector can be controlled with RS-
232C commands from the computer with web browser.
For details of RS-232C commands, refer to RS-232C Communication / Network
command table (&17).
NOTE • If data is transferred using wireless and wired LAN at the same time,
the projector may not be able to process the data correctly.
Connection
Turn off the projector and the computer.
1.
If you use wired LAN, connect the projector's LAN or HDBaseT
2.
computer's LAN or HDBaseT
fulfi lls the specifi cation shown in fi gure. If you use wireless LAN, insert the USB
wireless adapter into the WIRELESS port of the projector.
Turn the computer on, and after the computer has started up turn the
3.
projector on.
LW502/LWU502 User's Manual - Technical
020-001099-01 Rev. 1 (06-2016)
port with a LAN cable. Use the cable that
TM
WIRELESS port
LAN
LAN or
HDBaseT port
• LAN cable (CAT-5e or greater)
or
• For HDBaseT connection
- CAT-5e or greater
- shielded type (connectors included)
- straight cable
- single cable
Command Control via the Network
USB wireless adapter
TM
port to the
11