Planar PS4662T User Manual page 34

Advanced Menu
Baud Rate
Smart Light Control
Power Saving Config
Ethernet Setup
Factory Reset
30
Select the baud rate of the display's RS-232 port.
Options: 115200, 38400, 19200, 9600; Default: 19200
Enable dynamic contrast (DCR) or ambient light sensor.
Options: Off, DCR, Light Sensor; Default: Off
Options: Wake on VGA, Wake on All, Always On; Default: Wake on VGA
Note: For Wake on VGA and Wake on All, the display will enter power saving mode if no
signal is received for 5 minutes.
See the "Ethernet Setup" section on page 31.
Restore all settings to their default.
Options: No, Yes; Default: No
Planar PS Series User Guide