Turning The Display On - Planar PS4662T User Manual

Turning the Display On

Turning the Display On
1
2
3
Turning the Display Off
With the power on, press the power button on the remote or side control panel to
put the LCD panel in a standby mode. To turn off power completely, turn the AC
switch to "O" or disconnect the AC power cord from the power outlet.
Note:
standby mode.
Adjusting the Volume
1
2
Note:
Selecting the Input Source
Do one of the following:
Note:
18
Insert the power cord into the display and into the power outlet.
Ensure the AC switch is set to "—".
Press the power button on the remote or side control panel.
If there is no signal for a certain period of time, the LCD panel will automatically go into
Using the remote, press the
volume.
Press the button to temporarily turn off all sound. To restore the sound,
MUTE
press the button again.
MUTE
The analog audio out is variable.
• Using the remote, press the desired source button (
• Press the source button on the display's keypad. Use the arrow buttons (
select one of the following input sources and press
.
DISPLAYPORT
When the display cannot find a source, a "No signal" message will appear.
Planar PS Series User Guide
- or
VOLUME VOLUME
+ to increase or decrease the
1, 1,
DP HDMI HDMI
: ,
ENTER VGA HDMI
2, ).
VGA


) to
1, 2,
HDMI