dB Technologies VIO L210 User Manual page 38

Hide thumbs Also See for VIO L210:

Table of Contents

Available languages

The example shows the case in which you want to set a 3° angle between the 2 modules.

Before carrying out any other operation, make sure that once the movable arm is inserted [6], the hole of the

chosen angle is contained inside the loop as shown.

•

FLOWN CASE: insert only one pin in the hole on the chosen angle. The second pin can be housed in the

"PIN HOLDER" hole. Note that this type of configuration during the assembly allows changing the chosen

angle simply by moving the respective pin (with the movable arm inserted).

•

STACKED CASE: once the pin [5] is inserted into the hole of the chosen angle, lift module B as far as the

movable arm [6] allows. At this point, insert the second pin into the "ANGLE LOCK" position and release

module B. This way, module B is completely blocked by the two pins on the rear.

After assembly is completed, always make sure that all the pins have been completely inserted and are well

locked.

VIO-L210

English

Cod. 420120248 REV. 1.1

Table of Contents

Chapters

Table of Contents