Cleaning And Maintenance - Storz & Bickel GMBH Volcano Instructions For Use Manual

9. EASY VALVE
Caution! Hot surface!
Never leave Filling Chamber on VOLCANO
Detach the Valve Balloon from the fil-
ling Chamber. When you do so, the
Valve is automatically closed so that
the vapors in the Valve Balloon can-
not escape.
Detach Valve Balloon from Filling Chamber
Attach the Mouthpiece to the Valve
and allow it to lock in place.
Attach the Mouthpiece
to the Valve Balloon
To inhale, put the Mouthpiece to your
lips and press them lightly against the
Mouthpiece. By doing so, the Valve
opens and the vapors can be inhaled
from the Valve Balloon. As soon as
you remove the pressure from the
Mouthpiece, the Valve automatically
closes.
Press Mouthpiece against lips and
inhale slowly and evenly for several seconds
Stretch Valve
Balloon tight
20
9. EASY VALVE
As the content of the Valve
Balloon deflates, it may be
completely emptied by stret-
ching the Balloon taut and subse-
quently inhaling the content.

9.2. Cleaning and Maintenance

EASY VALVE Balloon with
Mouthpiece
The EASY VALVE Balloon and its
Mouthpiece require no maintenance.
for hygienic reasons, they should be
replaced with a new Valve Balloon
and Mouthpiece every two weeks. To
prevent any transfer of infectious
germs, the Valve Balloon and Mouth-
piece should be used only by one per-
son, and never shared by multiple in-
dividuals.
Filling Chamber with Filling Cham-
ber Cap
Please allow the filling Chamber and
the Cap to cool down before disas-
sembling them. The component parts
of the filling Chamber must be thor-
oughly cleaned on a regular basis to
guarantee proper operation and pure
flavor. for hygienic reasons, it is also
necessary to clean the filling Cham-
ber with Cap for hygienic reasons
when the device is to be used by a dif-
ferent person. If a new Valve Balloon
and Mouthpiece are used, the filling
Chamber should also be cleaned be-
forehand. for manual cleaning, use
rubbing alcohol and paper or cotton
towels or warm water with wash-up li-
quid. filling Chamber and Cap may be
easily disassemblend and reassem-
bled for cleaning in a few seconds.
filling Chamber and Cap Compo-
nents may also be cleaned in a dish-
washer. However, the Screens, Cap
Ring and filling Chamber Clips are
very small, and may be lost if placed
in a dishwasher. Before assembling
allow all component parts to dry prop-
erly.
Manual cleaning with alcohol (min. 90%)
Do not immerse any plastic
components in ethanol or al-
cohol for longer than an hour.
Extended contact with ethanol or al-
cohol may lead to discoloration or
embrittlement of plastic parts.
After cleaning, check all component
parts for surface damage, tears, sof-
tening or hardening, impurities, dis-
tortion and discoloration and set da-
maged component parts aside.
21