Safety Tips:
•
Slowly open dishwasher door while someone grasps the rear of the dishwasher. Remove shipping materials, drain
hose and lower rack. Close dishwasher door until latched.
•
Observe all governing codes and ordinances.
•
Install this dishwasher as specifi ed in these instructions.
•
Installation should be performed by a qualifi ed service technician. The dishwasher must be installed to meet all electri-
cal and plumbing national and local codes and ordinances.
Tools and Parts:
Gather the required tools and parts before starting installation.
Tools Needed for All Installations
•
Phillips screwdriver
•
Flat - blade screwdriver
•
5/16" and 1/4" nut drivers
•
Measuring tape or ruler
•
6" adjustable wrench
•
Small level
•
Flashlight
•
Shallow pan
Tools Needed for New Installations
•
Electric drill with 1/2", 3/4" and 1-1/2" hole saw bits
•
Small tube cutter
Parts Supplied:
A. 2 – # 8 x 5/8" Phillips fl at head wood screws
B. 4 – Phillips head, color matched toekick screws
Make sure these parts are included.
See separate parts list for accessories available for your dishwasher.
DISHWASHER SAFETY
WARNING:
Tip Over Hazard
•
Do not use dishwasher until completely installed.
•
Do not push down on open door.
•
Doing so can result in serious injury or cuts.
INSTALLATION REQUIREMENTS
Parts Needed for All Installations
•
90° elbow with 3/8" N.P.T. external threads on one
end. (The other end must fi t your water supply line).
•
Thread seal tape
•
3 UL listed wire nuts
•
One 1-1/2"-2" screw type clamp
Parts Needed for New Installations
•
Copper tubing (3/8" recommended)
•
Clamp connector to fi t a 7/8" (22.2 cm) diameter hole
•
One 1-1/2" -2" screw type clamp if connecting to
waste-tee
1
B
A