Complete Installation - Danby DDW1801MW Instructions Manual

Complete Installation

1. Place the lower panel behind the toekick panel.
2. Place 2-piece toekick against the legs of the dishwasher.
3. Place the inner toekick piece (with slots) against the toekick bracket. The slots should align with toekick bracket screw
holes. Allow the bottom edge of the lower toekick to touch the fl oor.
4. Place larger toekick over the inner piece and install 4 toekick screws. Use additional 2 screws for installations over 33-
1/2" (85.09 cm) high. Use both toekick pieces for all installation heights.
Direct Wire Method:
WARNING:
• Electrically ground dishwasher.
• Connect ground wire to green ground connector in terminal box.
• Do not use an extension cord.
• Failure to follow these instructions can result in death, fi re, or electrical shock.
Power Supply Cord Method
WARNING:
• Plug into a grounded 3 prong outlet.
• Do not remove ground prong.
• Do not use an adapter.
• Do not use an extension cord.
• Failure to follow these instructions can result in death, fi re, or electrical shock.
5. Reconnect power or plug in dishwasher
INSTALLATION INSTRUCTIONS
Adjust up and
down
Electrical Shock Hazard
Electrical Shock Hazard
Screw to Coun-
tertop
2 piece
toekick
18