Assembly/Panel Removal Manet Styling; Rear Cover; Speakers; Stand Support - Philips 32PFL8605H/12 Service Manual

4.6

Assembly/Panel Removal Manet Styling

(6000-series)
The instructions apply to the 42PFL6805H/xx.
4.6.1

Rear Cover

Warning: Disconnect the mains power cord before you remove
the rear cover.
1
1
4.6.2

Speakers

Each speaker unit is mounted with two screws.
When defective, replace the whole unit.
4.6.3

Stand support

Refer to Figure 4-6 for details.
1. Unplug the mains power connector [1] from the PSU and
release the cable from it's clamp.
2. Remove all screws [2] of the stand support.
3. Slide the stand support down in the direction of the
arrows [3] and then lift the support from the set.
2
1
2
Figure 4-6 Stand support
4.6.4 Mains Switch
The mains switch is mounted on the stand support.
1
Figure 4-5 Rear cover 32PFL6805x/xx (applicable to all 6000 series sets)
2
3
3
2
18754_102_100922.eps
Mechanical Instructions
Refer to Figure 4-5
1. Remove the stand using a hexagonal wrench.
2. Remove all metric screws [1] of the rear cover.
3. Remove the remaining plastite screws [2] of the rear cover.
4. Lift the rear cover from the TV. Make sure that wires and
flat coils are not damaged while lifting the rear cover from
the set.
1
1
4.6.5 Main Power Supply
Refer to Figure 4-7
2
2
2
100922
1. Unplug all connectors [1].
2. Remove the fixation screws [2].
3. Take the board out.
When defective, replace the whole unit.
back to
div. table
Q551.1E LA
for details.
1
2
2
2
for details.
1
1
Figure 4-7 Main Power Supply
4. EN 17
1
1
2
2
18754_101_100922.eps
100922
2
2
2
18750_102_100414.eps
100414
2010-Oct-01