Table of Contents
Advertisement
EN 12
4.
Q522.1E LA
4.2
Service Positions
For easy servicing of this set, there are a few possibilities
created:
•
The buffers from the packaging (see figure "Rear cover").
•
Foam bars (created for Service).
4.2.1
Foam Bars
Required for sets
1
42"
Figure 4-5 Foam bars
2
2
2
Mechanical Instructions
1
E_06532_018.eps
171106
2
2
Figure 4-6 Back Cover Removal
The foam bars (order code 3122 785 90580 for two pieces) can
be used for all types and sizes of Flat TVs. See figure "Foam
bars" for details. Sets with a display of 42" and larger, require
four foam bars [1]. Ensure that the foam bars are always
supporting the cabinet and never only the display.
Caution: Failure to follow these guidelines can seriously
damage the display!
By laying the TV face down on the (ESD protective) foam bars,
a stable situation is created to perform measurements and
alignments. By placing a mirror under the TV, you can monitor
the screen.
4.3
Assy/Panel Removal ME8 Styling
4.3.1
Rear Cover
Warning: Disconnect the mains power cord before you remove
the rear cover.
Note: it is not necessary to remove the stand while removing
the rear cover.
Refer to next figures for details.
1. Remove the screws [1] and [2].
2. Lift the back cover from the TV. Make sure that wires and
flat coils are not damaged while lifting the rear cover from
the set.
2
2
2
2
1
1
1 1
2
2
I_17750_007.eps
250208
Advertisement
Chapters
Table of Contents
