Configuring Your Phone - Yealink SIP-T58A Quick Start Manual

Startup
After the IP phone is connected to the network
and supplied with power, it automatically begins
the initialization process. After startup, the
phone is ready for use. You can configure the
phone via web user interface or phone user
interface.

Configuring Your Phone

Configuring via web user interface
Accessing the web user interface:
1. Swipe down from the top of the screen to enter the control center.
2. Tap Settings->Status to obtain the IP address of the phone.
3. Open a web browser on your computer, enter the IP address into the address bar
(e.g., "http://192.168.0.10" or "192.168.0.10"), and then press Enter.
4. Enter the user name (default: admin) and password (default: admin) in the login page and click
Confirm.
Network Settings: Click on Network->Basic->IPv4 Config
You can configure the network settings in the following ways:
DHCP: By default, the phone attempts to contact a DHCP server in your network to obtain
its valid network settings, e.g., IP address, subnet mask, gateway address and DNS
address.
Static IP Address: If the phone cannot contact a DHCP server for any reason, you need to
PPPoE: If you are using an xDSL modem, you can connect your phone to the Internet via
PPPoE mode. Contact the ITSP for the PPPoE user name and password.
Note: The IP phone also supports IPv6, but IPv6 is disabled by default.
The wrong network settings may result in inaccessibility of your phone and may have an impact on the
network performance. Contact your system administrator for more information.
Account Settings: Click on Account->Register->Account X (X=1,2,3...15,16)
Parameters of the account:
Register Status:
Line Active:
Label:
Display Name:
Register Name:
User Name:
Password:
Server Host:
5
configure IP address, subnet mask, gateway address, primary DNS address
and secondary DNS address for the phone manually.
It shows the register status of the current account.
You can select Enabled/Disabled to enable/disable the account.
It is shown on the touch screen to identify the account.
It is shown as Caller ID when placing a call.
It is an authenticated ID for authentication provided by ITSP (required).
It is provided by ITSP for registration (required).
It is provided by ITSP for registration (required).
It is provided by ITSP for registration (required).
Welcome
nitializing... Please wait
I