Table of Contents
Advertisement
4
UC Surface Monitor Control Software
4.7
The Settings Page
The Settings Page
4.7
4.7.1 Device Settings Tab: System Settings
The Settings page allows you to configure your Studio 192-series interface. To open
the Settings page, click on the Settings button in the upper right-hand corner
The System Settings area allows you to customize the
following parameters on UC Surface:
Mixer Bypass. Bypasses UC Surface mixer and routing.
Click this button to disable all UC Surface Mixer functions. While Mixer Bypass is
active, your Studio 192-series interface will function as a simple I/O device for
your DAW.
When the mixer is bypassed, you must route audio to the desired output using its
dedicated playback stream both for system playback (if desired) and DAW playback.
Peak Hold. Disables peak hold metering.
By default, peak hold metering is active. To change to peak metering, click the
Off button.
Standalone mode (Studio 192 only). Sets the functionality
when not connected to a computer.
When not connected to a computer, your Studio 192 will function as stand-alone A/D
converter. You can set analog outputs 1-8 to either function as direct preamp outputs
or DAC outputs, depending on your needs. By default, these outputs are in D/A
Conversion mode and will receive their source signals from their corresponding
ADAT/dual SMUX channels. You can set the analog outputs to receive their source
signal from their corresponding analog inputs by selecting Preamp mode from
Analog Output Mode menu.
Power User Tip: Once you have configured your Studio 192's standalone
functionality, it will stay in that configuration while disconnected from your
computer, even after a power cycle. It is important to note that Stand-Alone mode
settings do not affect normal operation while connected to a computer.
Note: Headphones 1 and 2, Main, and S/PDIF outputs are disabled in Stand-Alone mode.
Talkback Source. Sets the source for the talkback mic.
The default source for the Studio 192 is the onboard mic; for the Studio 192 Mobile,
this is set to 'None' . For either device, you can select any preamp as the
talkback source.
Speaker management. Sets speaker-management functionality.
By default, speaker management is disabled, and each pair of outputs on your
Studio 192-series interface has its own mix in UC Surface. When speaker
management is enabled, the Main L/R outputs (A), analog outputs 1/2 (B), and analog
outputs 3/4 (C) can be used for speaker switching and the Main level control can be
used to control outputs A, B, and C.
• A – B – C. Each pair of outputs is mutually exclusive. Use this setting
when switching between three pairs of full-range studio monitors.
• A – B + C. Outputs A and B are mutually exclusive and Output C
can be added to either. Use this setting when switching between
two pairs of full-range studio monitors with a subwoofer.
• A + B + C. Outputs A, B, and C can all be active at the same
time. This setting is useful while mixing in 5.1.
Note: When exiting speaker management mode, Mixes
1/2 and 3/4 will mute automatically.
Studio 192 and Studio 192 Mobile
Owner's Manual
30
Hide quick links:
Advertisement
Table of Contents
