Fat Channel Presets - PRESONUS Studio 192 Owner's Manual

4 UC Surface Monitor Control Software
4.3 Dynamics Processing and EQ

4.3.3 Fat Channel Presets

1
2
3
4
5
6
7
- EQ Frequency. Adjusts the center frequency of each band.
- EQ Gain. Sets level of the center frequency from -15 to +15 dB.
- Q. Sets the Q for the each band. The Q is the ratio of the center
frequency to the bandwidth. When the center frequency
is constant, the bandwidth is inversely proportional to the
Q, so as you raise the Q, you narrow the bandwidth.
3. High Pass Filter. Sets the highpass filter's frequency threshold for the selected
channel or output bus. The filter's threshold can be set from 24 Hz to 1 kHz.
When the meter is set to its lowest point, the filter is off. The highpass filter is
available on all input channels and on auxiliary and effects output buses only.
Power User Tip: A highpass filter attenuates all frequencies below the set
threshold. Use the Fat Channel highpass filter to remove unwanted low
frequencies from your source signal, rather than trying to EQ them out.
4. EQ Graph. This graph shows the overall EQ curve.
UC Surface provides 50 Fat Channel presets, giving you a quick way to set up
channels for monitoring. To access them, click on the Presets button from the Fat
Channel to open the Preset Manager.
8
1. Channel selection. Displays the currently selected channel. The preset
manager will automatically load and store presets to and from this
channel. Click on this menu to select a new channel to manage.
2. Preset category. Filters the preset list based on the selected category.
3. Add Preset (+). Creates a Fat Channel preset from
the currently selected channel's settings.
4. Preset filters. Filters Fat Channel presets by module (gate, compressor/limiter, EQ).
To load any of these preset components, just click on the component's button.
5. Load. Loads the current preset to the selected channel.
6. Audition. By engaging the Audition button, each preset will
nondestructively load into your channel with the currently enabled
filters. This lets you try out a preset before loading it and overwriting
the current settings. You can make changes to this preset in real time.
To load the settings you've auditioned, click the Load button.
7. Reset. Restores the Fat Channel to its default settings. The Preset Load
filters can be used to configure which settings will be reset.
8. Previous/Next channel. Selects the previous or next channel.
Studio 192 and Studio 192 Mobile
9 10
Owner's Manual
11
21