Uc Surface Launch Window - PRESONUS Studio 192 Owner's Manual

4 UC Surface Monitor Control Software
4.1

UC Surface Launch Window

UC Surface Launch Window
4.1
Sample Rate. Changes the sample rate.
You can set the sample rate to 44.1, 48, 88.2, or 96 kHz. A higher sample
rate will increase the fidelity of the recording but will increase the file size
and the amount of system resources necessary to process the audio.
At 44.1 and 48 kHz, all DSP functions are available. At 88.2, 96,
176.4, and 96 kHz, Fat Channel processing will be available on
analog inputs only and the delay bus will be disabled.
Safe Mode (Windows only). Adjusts the Input Buffer Size.
These modes allow you to adjust the input buffer size
to optimize performance for your computer.
When adjusting the safe mode, the block size will be adjusted
automatically to provide the best performance.
Clock Source. Sets the digital clock source.
From this menu, you can set the clock source for your Studio
192-series interface: Internal, External S/PDIF, or External ADAT.
Please note: Only ADAT 1 can be used as a clock source
input for your Studio 192-series interface.
Block Size. Sets the buffer size.
From this menu, you can set the buffer size from 32 to 4,096 samples (Mac), or 64
to 8192 samples (Windows). Lowering the buffer size will lower latency; however,
this will also increase performance demands on your computer. In general, you will
want to set the buffer size as low as your system can safely support. If you begin
to hear pops, clicks, or distortion in your audio path, try raising the buffer size.
A Note for Windows users: When adjusting the block size, the Safe
Mode will automatically change to provide the best performance.
Studio 192 and Studio 192 Mobile
Owner's Manual
15