Table of Contents
Advertisement
Programming a standalone show
You can program a standalone routine, or show, to run without a controller or if DMX control is suddenly
lost. The show can have up to 20 separate effects, or scenes, that display for up to 10 minutes each.
Scenes can be programmed to fade from one scene to the next over a period of 0 to 120 seconds.
Note: To enable standalone operation, the DMX STATE setting in the FIXTURE CONFIG menu must be
set to SHOW MODE. See page 19. The show will run only when there is no DMX input.
To program a standalone show:
1.
Access the control menu and select PROGRAM SHOW. Press ENTER.
2.
Set the number of scenes. Select SET SCENE TOTALS and press ENTER. Use the arrow buttons to
select from 1 to 20 scenes. Press ENTER.
3.
To modify scene colors (on 200 and 210 models) or color temperatures (on the 220 model):
a)
Select EDIT SCENE COLOR and press ENTER.
b)
Scroll to a scene to modify and press ENTER.
c)
Select the attribute to change (red / green / blue / white, or warm white / cold white) and press
ENTER.
d)
Press the UP arrow to increase the attribute or the DOWN arrow to decrease it. When satisfied
with the amount, press ENTER.
e)
Repeat steps c) and d) for each attribute.
f)
Press MENU to select the next scene to modify.
g)
When done editing scenes, press MENU again to return to the PROGRAM SHOW menu.
4.
To modify scene transitions, select FADE TIME and press ENTER. Press UP or DOWN to select a
fade time from 0 to 120 seconds. Press ENTER.
5.
To modify the length of time each scene is displayed before fading to the next scene, select HOLD
TIME and press ENTER. Press UP or DOWN to select a duration from 0 to 600 seconds. Press
ENTER.
Manual mode
Fixture output can be set manually from the control panel as follows:
1.
Access the control menu and select MANUAL MODE. Press ENTER.
2.
Select an attribute to modify and press ENTER.
3.
Adjust the attribute level from 0 to 255 with the arrow buttons. Press ENTER.
4.
Repeat for each attribute.
5.
To exit manual mode, press MENU.
Display setting
The DISPLAY SETTING menu provides options to invert, dim, and turn off the control panel display.
Display inverse
For easier reading when the fixture is mounted upside down, flip the display as follows:
1.
Access the control menu and select DISPLAY SETTINGS. Press ENTER.
2.
Select DISPLAY INVERSE and press ENTER.
3.
Select YES to invert the display or NO for normal reading.
4.
Press ENTER.
Display auto turn off
The display can be set to stay on or to turn off 1 minute after the last key press. To set display behavior:
1.
Access the control menu and select DISPLAY SETTINGS. Press ENTER.
2.
Select DISPLAY AUTO TURN OFF and press ENTER.
3.
Select NO to keep the display illuminated, or YES to have the display turn off automatically after 1
minute.
4.
Press ENTER.
TM
Exterior Wash
200 Series User Manual
17
Advertisement
Table of Contents
