To install an optional diffuser lens:
1.
Shut down power to the fixture.
2.
Position the diffuser lens over the front with the labelled, smooth side facing out.
3.
With the cut-out channels in the silicone gasket facing out, align the channels in the gasket with the
drain channels at the bottom of the front ring.
4.
Press the diffuser lens gasket firmly into the recess in the front ring.
5.
Either place a trim ring over the diffuser and fasten with provided hardware, or install a snoot as
described below.
Installing a snoot
The optional snoot for Exterior Wash
(see above). To install, shut down power to the fixture, then align the snoot to fit over the front of the
fixture and fasten securely with the included hardware.
12
Align channels in gasket and front ring
™
200 Series fixtures may be installed with or without a diffuser lens
Snoot installation
TM
Exterior Wash
200 Series User Manual