Basic Channel Operations; Open The Channel Setup Menu - Fluke 2638A User Manual

2638A
Users Manual

Basic Channel Operations

Use the instructions in this section to perform basic channel operations.

Open the Channel Setup Menu

The Channel Setup menu lets the user manage channels, verify inputs, and also set up
tests. To open the menu, push
To select channels, use the  and  arrow keys. To quickly move up and down the list
of channels, use the  and  arrow keys.
Item
Module indicator that has three bars to show which Input Modules are connected and registered.
The top indicator is slot 1, the middle indicator is slot 2, and the bottom indicator is slot 3. When a

module is in a slot, the indicator is green. When a slot is empty, the indicator is white.
Channel status. When ON, the channel can be configured and the channel status indicator to the
left of the channel is green. When OFF, the channel information is not shown and the channel

status indicator is white.
List of available channels. Channels show in the list only when an Input Module relay card is
installed in a slot. For example, Ch201 through Ch222 will not show in the channel list until an
Input Module relay card is installed into slot 2.

3-10
info@Fluke-Direct.com
The Channel Setup menu cannot be accessed while a scan is in progress.
Table 3-3. Channel Setup Menu
4
Ch001 is always the front-panel terminals and always shows in the channel list.
Fluke-Direct

on the front panel.
Note
3 2
5
Function
Note
1
hce032.eps
.com
1.888.475.5235