Table 36: Show System Resource-Profile Output Fields - Alcatel-Lucent 7210 SAS M Configuration Manual

System Commands
Parameters active|configure — keyword - Displays active or configured values.
policy-id — Specifies a resource profile policy.
Output Show resource-profile Output — The following table describes resource-profile output fields.
Page 498
Active values are those in use by the system currently. Configured values are those that have
been changed by the user and has not taken effect. For the system resource-profile parameters
that need a reboot to take effect, the active and configured values can be different. It typically
requires a node reboot or a card reset for it to take effect.

Table 36: Show system resource-profile output fields.

Label
Ingress Queue
Mode
Ingress Internal
CAM
Sap Ingress ACL
resource
IPv4 Resource
IPv4-IPv6
Resource
Mac Resource
IPv6-64 bit
Resource
Eth CFM
up-mep
Sap Ingress QoS
resource
7210 SAS M, T, X, R6 Basic System Configuration Guide
Enable – Enables SAP ingress queuing
Disable – Disable SAP ingress queuing
Displays the applications sharing ingress CAM resource.
Displays the resources configured for use by SAP Ingress ACL
policies.
Displays the resources configured for use by ingress ACL poli-
cies that use ipv4-criteria.
Disable – No resources are allocated for use by this feature.
Therefore, no policies of this type can be associated to a SAP.
Displays the resources configured for use by ingress ACL poli-
cies that use ipv6 128-bit address match-criteria.
Disable – No resources are allocated for use by this feature.
Hence, no policies of this type can be associated to a SAP.
Displays the resources configured for use by ingress ACL poli-
cies that use mac-criteria.
Disable – No resources are allocated for use by this feature.
Hence, no policies of this type can be associated to a SAP.
Displays the resources configured for use by ingress ACL poli-
cies that use ipv6 64-bit address match-criteria.
Disable – No resources are allocated for use by this feature.
Hence, no policies of this type can be associated to a SAP.
Groups the context for resources consumed by Ethernet CFM
applications.
Displays the resources configured for use by UP MEP.
Disable – No resources are allocated for use by this feature.
Therefore, no UP MEPs can be created.
The total amount of ingress internal CAM chunks configured for
use by SAP ingress classification.
Description