Example Configuration On Use Of Ptp And Synce References On 7210 Sas-T And 7210 Sas-R6 - Alcatel-Lucent 7210 SAS M Configuration Manual

System Basics Introduction
config> system> sync-if-timing> commit
Note : Now the frequency is provided by SyncE and TOD is provided by PTP [configure >system
>ptp >no shutdown]. This is called PTP Hybrid mode.
3. To change back to Stand alone PTP from SyncE, the following must be executed:
config> system> sync-if-timing> begin
config> system> sync-if-timing> commit
config> system> sync-if-timing> begin
config> system> sync-if-timing> commit
Note: Now the Frequency and Time is provide by PTP [configure >system >ptp >no shutdown]
only. This is a standalone PTP mode.
Example configuration on use of PTP and syncE references on
7210 SAS-T and 7210 SAS-R6
The configuration example for 7210 SAS-T showing use of PTP and syncE references
simultaneously is as below:
Page 242
ql-selection -------------------> Optional , if we need Quality to be consisdered .
ref1
source-port 1/1/10
figured, but in admin down state
shutdown
exit
ref2
source-port 1/1/11
figured, but in admin down state
shutdown
exit
ptp
no shutdown
exit
ref-order ptp [Must be configured]
7210 SAS M, T, X, R6 Basic System Configuration Guide
--------------------> Not Required if port is already con-
--------------------> Not Required if port is already con-