Table of Contents
Advertisement
note
To order accessories from
Epson,
call (800) 873-7766,
or visit the Epson Stori
M
at
www.epsonstore.com
(US.
sales only). In Canada, call
(800)
463-7766
for dealer
referral.
Solving Problems
Solving Problems with the Image
No image appears on the screen.
•
Check that all cables are properly connected (see Chapter 1) and
everything is turned on.
•
Make sure the power switch is turned on.
•
Make sure the projector or computer is not in sleep mode. Check
the projector documentation,
or try pressing a key on the
computer keyboard.
•
The document camera may have been turned on too quickly after
it was turned off. Turn the document camera off, wait a few
seconds. and then turn it on
again.
•
The wrong source may be selected. Try pressing the Main, RGB1,
or RGB2 button on the remote control or document
camera.
•
You may need to change the NTSC or PAL DIP switch setting on
the document camera. See page 20 for instructions.
The image contains static or noise.
•
If you' re using cables that are longer than 6 feet (2 m]. or an
extension cable, the image quality may be reduced. Try using the
cables supplied with the document camera. If longer cables are
required. consider using a distribution amplifier such as the one
available from Epson (ELPDA01).
•
Keep your projector, computer, and video cables away from the
power cord as much as possible to prevent interference.
•
The camera's DIP switches may be set incorrectly. Try adjusting
the switches as described on page 20.
•
Try pressing the
CLEAR MODE
button on the document camera,
especially if you're taking pictures of three-dimensional
objects.
•
If you notice a decline in the projected image quality when the
image is displayed simultaneously on your laptop computer and
projector, turn off the laptop's LCD display.
Advertisement
Table of Contents
