Table of Contents
Advertisement
Projecting
Transparencies
The document camera enables you to project both positive and
negative film with great clarity. Follow these steps:
1.
Place your film or slides on the document camera's stage with the
dull side facing up.
2.
Do one of the following to turn the upper lamps off and the base
lamp on:
•
Press the UPPER LAMP button on the remote control, and
then the BASE LAMP button.
•
Press the LAMP button on the document camera.
3.
If you're projecting negative film, press the POSI/NEGA button
on either the remote control or document camera.
If you want to continue normal projection when you're done, turn the
base lamp off and the upper lamps on again. If you were projecting
negative film, press the POSI/NEGA button again to return to normal
display.
I
Switches between
normal projection and
negative film projection
Turns the
lamps on
and off
Switches between normal
projection and negative film
projection
1<
2.
3>
---
PAlJSE
4~
S.
-- -
~
6<
n
8>
---
!
l.PRESE.
Jl.
MN3
1i
'-
~~_w
. lAMlL
f-
MAIN
...•...
I NPUT
...•....•
RGB1-
RGB2
- --
.zcoo.llil
OCU
•
•• ••-ll-
--IRIS--
Turn upper lamps off and
base lamp on
note
It may take a few seconds for
the base lamp to come on.
Using the Document Camera
Advertisement
Table of Contents
