Weller WR 2 Operating Instructions Manual page 30

6-20
4.1 Technical data of WR 2
Dimensions
Weight
Mains supply voltage
Power consumption
Safety class
Fuse
Temperature control of
channels
Temperature accuracy
Temperature accuracy
HAP 1
Temperature stability
Soldering tip leakage
resistance (tip to ground)
Soldering tip leakage
current (tip to ground)
Pump (periodic duty
(30/30) s)
Equipotential bonding
Equipotential bonding
Due to the different configuration of the 3.5 mm jackplug socket
(equipotential bonding socket) (27),
4 variants are possible:
− Hard earthed/grounded: without connector (delivery status)
− Centre contact.
− Floating: with connector
− Soft earthed: with connector and soldered resistor.
Earthing via the selected resistor
L x B x H (mm): 273 x 235 x 102
L x W x H (inches): 10.75 x 9.25 x 4.02
approx. 6.7 kg
230 V, 50 Hz (120 V, 60 Hz)
300 W
I and III, housing antistatic
Overcurrent release 1.5 A
Soldering and desoldering tool,
continuously variable from
50 °C – 550 °C (150 °F – 999 °F)
Controllable temperature range is tool-
dependent
WP 80 / WP 120
50 °C - 450 °C (150 °F - 850 °F)
WP 200
50 °C - 550 °C (150 °F - 999 °F)
WSP 150
50 °C - 550 °C (150 °F - 999 °F)
DSX 80 / DSXV 80
50 °C - 450 °C (150 °F - 850 °F)
HAP 1
50 °C - 550 °C (150 °F - 999 °F)
± 9 °C (± 20 °F)
± 30 °C (± 50 °F)
± 2 °C (± 5 °F)
corresponds to IPC-J-001
corresponds to IPC-J-001
Max. vacuum 0.7 bar
Max. delivery rate 10 l/min
Hot air max. 15 l/min
Via 3.5 mm pawl socket on back of
device
WR 2