Page 1
WR 2, WR 3M D E Originalbetriebsanleitung G B Translation of the original instructions E S Traducción del manual original FR Traduction de la notice originale Traduzione delle istruzioni originali P T Tradução do manual original S L Prevod izvirnih navodil N L Vertaling van de oorspronkelijke E E algupärase kasutusjuhendi tõlge...
For your safety These instructions contain important information The device has been manufactured in accordance The device has been manufactured in accordance Read these instructions and the accompanying safety information carefully before starting up the device and starting work with the device. Warning! Fire and explosion hazard! Warning! Danger of injury ted in the operating instructions of soldering and...
For your safety User groups Work step User groups Specialist personnel with technical training Replacing electrical replacement parts Electricians Operation Filter change Operation Technical trainees under the guidance and supervision Filter change Replacing electrical replacement parts Starting up the device Caution! Please adhere to the operating instructions of the connected devices.
Floating with plug Notice The control unit is equipped with a Mini USB port. To use the USB port, Weller provides software on a www.weller.de/de/Weller--Download-Center--Software-Updates.html so you can carry out a software update („Firmware Updater“) on your control unit. Care and maintenance...
Parameter menu Standby Temp. (STANDBY) Menu access - 1 - Setback time (SETBACK) Menu access - 1 - If the soldering tool is not in use, the temperature Option Description Vacuum pre-feed (VAC On) Menu access - 1 - In order to prevent the pump from starting pre Option Description Vacuum run-on (VAC Off)
Page 6
Menu access - 1 - WR 3M: following buttons on the soldering station are WR 2: WR 3M: Unlocking the soldering station All other settings are disabled until the repair Notice If you want only one temperature value to be WR 2: keys) must be set to the same temperature value.
Page 7
Menu access - 2 - temperature precision of the repair station and difference between the value indicated on the corresponding channel must be selected prior to WR 2: WR 3M: WR 2: WR 3M: Resetting calibration to factory settings WR 2:...
Page 8
The function determines the heating characteris Option Description tics of the soldering tool to achieve the set tool Slow heating rapid heating Resetting to factory settings (FSE) WR 2: WR 3M: GlobalTestSupply www. .com Find Quality Products Online at: sales@GlobalTestSupply.com...
Technical Data Repair station WR 3M WR 2 Power consumption I, antistatic housing III, Soldering tool Fuse 1,6 A Temperature (Tool dependent) °F Additional vacuum pump GlobalTestSupply www. .com Find Quality Products Online at: sales@GlobalTestSupply.com...
Error messages and error clearance Message/symptom Possible cause Remedial measures Tool has not been detected device Tool defective Turn on mains power switch OFF) Vacuum not connected vacuum connection Service desoldering nozzle using cleaning tool Filter cartridge on desoldering tool full desoldering tool full ring tool on the soldering station...
Page 11
Original declaration of conformity Repair station WR 2, WR 3M Managing director Technical director Warranty GlobalTestSupply www. .com Find Quality Products Online at: sales@GlobalTestSupply.com...