Review Of Installer, Owner, & Maintenance Menu Programming; Pool Volume; Calibrating Salt; Select Language - Aquacal Pool Pilot Digital Nano Owner's Manual


"##,### gallons (liters)" (The pool volume programmed in Installation Menu; 15,000 is the
factory setting)

"Reverse = # hrs." (The reverse rate programmed in Installation Menu: 4 hrs. is factory
setting)

"Temp. adjust = #" (The temperature adjustment variation of actual Tri-Sensor reading;
page 20)

"Salt adjust + # %" (The salt calibration adjustment variation of actual Tri-Sensor reading;
page 19)

"Logging" (only appears if logging feature is enabled)

"Shutoff Temperature" (Internal temperature of the unit at which it goes into a 5 minute
cool-down period.

"Max Temp" (Maximum internal temperature reached)
7.6 REVIEW OF INSTALLER, OWNER, & MAINTENANCE MENU PROGRAMMING
NOTE: Once determined to be appropriately programmed for the installation site, the following menu
items should not require regular access. See "Basic Operational Programming," for setting initial
Chlorine Level and routine control instructions.

7.6.1 Pool Volume

Must be programmed for the "salt amount needed" display to be accurate.
1) Press MENU, press
for 13 seconds.
2) Press or
Factory setting is 15,000 gallons. The range is 500 to 125,000 gallons (1,000 to 226,000
liters)
3) Press or
4) Press or

7.6.2 Calibrating Salt

Note: The unit has been calibrated at the factory and should not require further adjustments. In the
event the salt display does not match on-site test results, follow these steps (it is necessary to wait
2 minutes after start-up before calibrating salt):
1) Press MENU, Press
2) Press or
3) Press or
then press SELECT. The maximum adjustment is ± 1000 ppm (mg/L).
4) Press or

7.6.3 Select Language

Allow for personal preference language display.
1) Press MENU, press
2) Press or
setting).
3) Press or
displayed; then press SELECT. (Digital Nano/Nano + may also include "Lingua Italiana" or
"Cesky Jazyk".
4) Press or
until "Installer Menu" is displayed; then press and hold SELECT
or
until "Set Pool Volume" is displayed; then press SELECT.
until correct pool size is displayed; then press SELECT.
until "End Menu Mode" is displayed; then press SELECT.
until "Maintenance Menu" is displayed; then press SELECT.
or
until "Calibrate Salt" is displayed; then press SELECT.
until the number on the display matches the accurately measured pool sample;
until "End Menu Mode" is displayed; then press SELECT.
until "Owner or Installer Menu" is displayed; then press SELECT.
or
until "Select Language" is displayed; then press SELECT (English is the factory
until desired language "English", "Idioma Española", "Langue Francais", is
until "End Menu Mode" is displayed; then press SELECT.
Page 19