Programming At Installation - Aquacal Pool Pilot Digital Nano Owner's Manual

Page 30

8.9 PROGRAMMING AT INSTALLATION

The Digital Nano/Nano + requires the pool volume be initially programmed into the installer menu. The
control center will then indicate how many pounds (kgs) of salt to add should salt levels fall. The
default pool size is 15,000 gallons (56,781 liters). The salt chart (on page 39) can also be used to
calculate how much salt in pounds (kgs) should be added to reach the recommended level of 3000
ppm (mg/L) salinity.
1. Enter the Installer Menu and program "Set Pool Volume" for specific pool. See Calculating Pool
Volume on page 28.
o Press MENU,
o Press
o Press and hold "SELECT" for 13 seconds to enter the Installer Menu.
o Press
 Factory setting is 15,000 gallons.
 The range is 500 to 125,000 gallons (2,000 to 500,000 liters)
o Press
o Press
2. Configure the following as needed. See Section 7.6 on page 19 for more information.

"Select Language"

"Select Units"

"Temperature Units"

"Audio Alarm"
3. Press or
until "Installer Menu" is displayed;
or
until "Set Pool Volume" is displayed; then press SELECT.
or
or until correct pool size is displayed; then press SELECT.
until "End Menu Mode" is displayed; then press SELECT.
or
to adjust chlorine output to 50%.