Menus; Basic Operational Programming; Adjusting The Chlorine Output - Aquacal Pool Pilot Digital Nano Owner's Manual

Page 16

7.2 MENUS

Test Pool Pilot
Salt
Salt Needed
Temperature
Cell V/A
Amp Hrs
View Setup
Software Version
Serial Number
Display Software Version
Power Level
Audio Alarm On / Off
Pool Size
Reverse Time
Temp Adjust
Salt Adjust
Shutoff Temp
Max Onboard Temp

7.3 BASIC OPERATIONAL PROGRAMMING

7.3.1 Adjusting the Chlorine Output %

Typically, once the initial setting is established, very little adjustment is needed. The chlorine % setting
refers to the amount of time the cell is energized within a 15 minute cycle. The system cycles on-and-
off, as indicated on the display's lower right display and "ON," when generating chlorine. Higher
settings will generate more chlorine.
1) Press the UP/DOWN (

Adjust the chlorine output percentage to the desired output: from 0% (off) to 100 %
(maximum output); then, press SELECT to default back to the normal display.

At startup of a new system, the standard output setting starting point is 50%.
Follow the instructions in the chart on page 36 to determine and correct chlorine% settings.
Example:
50% setting = 50% of 15 minutes or 7.5 minutes ON and 7.5 minutes OFF.
25% setting = 3.75 min ON, 11.25 min OFF
Once the percentage is set, the unit will implement the temperature compensation algorithm based on
current water temperature.
Maintenance Menu
(Factory Set)
or ) arrow buttons to enter the chlorine adjustment mode.
Main Menu
Test Pool Pilot
View Setup
Owner Options
Installer Menu
End Menu Mode
Owner Options
Select Language
Select Units
Temperature Unit
Audio Alarm
End Menu Mode
Maintenance Menu
Force Reverse
Set Reverse Time
Replace Cell
Calibrate Salt
Calibrate Temperature
End Menu Mode
Installer Menu
Select Language
Select Units
Temperature Unit
Set Pool Volume
Audio Alarm
Enable Demo
End Menu Mode