Section 7 - Programming; Control Panel; Button Overview; Menu Button - Aquacal Pool Pilot Digital Nano Owner's Manual

SECTION 7 - PROGRAMMING

7.1 CONTROL PANEL

7.1.1 Button Overview

Push UP or DOWN arrow to
do the following:
 Sets Chlorine Level %*
 Scrolls through Menus
and Sub-Menus
 Increases or Decreases
programming values for
menus.
Push BOOST:
 Select to start 24 hour
boost mode.
 Select and hold for eight
(8) seconds to start 72
hour boost mode.
 Select again to cancel
boost mode.

7.1.2 Menu Button

The MENU button is used to leave the normal operation mode and enter the program and diagnostic
modes. Use the UP/DOWN arrows and SELECT buttons to navigate through the menus and sub-
menus. Note: to permit quick access to features, some functions are accessed or programmed in
several menus.

Test Pool Pilot - displays various operating parameters and diagnostic results

View Setup - displays the programmed setup parameters

Owner Options - programs the primary operating parameters an owner would need to change

Maintenance Menu - tests and programs the primary features a service technician would need
to access when servicing the system

Installer Menu - program the initial system setup
SELECT Button
The SELECT button chooses the displayed menu option. For the Installer Menu, press and hold the
SELECT button for approximately 13 seconds to access this feature. The SELECT button also
temporarily disables the buzzer during an error display.

7.1.3 Display Overview

The first line of the display typically indicates Chlorine Output Level in percent, or whether the system
is in Boost or Super-Boost mode. The second line displays temperature in Fahrenheit or Celsius and
chlorine on/off mode. A small dot in bottom right corner indicates the self-cleaning forward/reverse
cycle.
Push MENU:
Leave normal operation and
access menus for programming
and diagnostics
Page 15
CHECK SYSTEM LIGHT:
 Red LED flashes to warn
attention is required.
 A warning message will
also be displayed.
 If enabled, an audio alarm
may also be heard when
the system light is flashing.
Push SELECT
Chooses item currently
displayed.